REASSEMBLY (SHEET 1 OF 3) - TM-5-3805-262-34

CLEANING, INSPECTION AND REPAIR (SHEET 2 OF 2)

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
656

TM 5-3805-262-34 3-14. STEERING GEAR MAINTENANCE (CONT) REASSEMBLY (SHEET 1 OF 3) a. If bushing (39) was removed, install new O-ring (40) in housing (41) bore for bushing. b. Put housing (41) in hydraulic press with bushing (39) bore upward. Position bushing in bore. Using proper size sleeve or rod, press bushing into bore until bushing stops moving. c. Put housing (41) in soft jawed vise. Using a screwdriver, start retaining ring (38) into groove in housing. Then, push retaining ring into housing groove. d. Put housing (41) in hydraulic press with bushing (39) upward. Position new seal (31) in bore of bushing with seal lip toward outside of housing. Using proper size rod, press seal into bushing. e. Install new O-rings (35) on valve spool (34). Large diameter O-ring must be installed on threaded end of valve spool. f. Install retainer (37) in valve spool (34) bore. Be sure retainer is flat in bottom of bore. g. Install check ball (36) in valve spool (34) bore. h. Install valve spool (34) in its bore. Be sure threaded end of valve spool is upward. i. Install plug (33). Tighten plug to 100 lb-in. j. Install seal (32) from bottom of housing (41) into bottom of bushing (39). Hold seal in position using your finger. Using screwdriver, push seal into bushing. k. Put oil-soluble grease on O-ring (23). Install O-ring in groove of housing (41). l. Apply clean lubricating oil to outside of valve spool (28) and inside of sleeve (30). Install valve spool in sleeve. Valve spool must be installed straight into sleeve. Turn valve spool in both directions as it is pushed into sleeve. 3-518

Privacy Statement
Press Release
Contact