TM 5-3805-262-34
3-15. AUXILIARY STEERING PUMP AND MOTOR MAINTENANCE (CONT)
a. Flowmeter Test (SHEET 3 OF 5).
(8) Set
(9)
(lo)
(11)
(12)
(13)
flowmeter controls as follows:
RANGE switch to LOW position
ON/OFF switch in ON position
PRESSURE VALVE control comple
FLOW switch in FLOW position
If hydraulic oil is cold, start
and operate engine at full
throttle.
Place bucket control lever in
CROWD position and hold for two
minutes then place control
lever in NEUT. position for one
minute.
Repeat step (10) above until
manifold (8) is warm to touch.
tely open
Decrease engine speed to idle, lower bucket to ground, and turn off
engine.
Connect l
charging
posts of
oad
Syst
one
leads of
em tester
battery a
start and
to battery
s shown
3-528
