TM 5-3805-262-343-15. AUXILIARY STEERING PUMP AND MOTOR MAINTENANCE (CONT)b. Removal, Separation.Joining, andInstallation.This task covers removal andinstallation of auxiliary steering pump and motor. It also covers separation of thisunit into pump section and motor section and joining of the two into a complete aux-iliary steering pump and motor.TOOLS: No. 1 Common Organizational Maintenance Tool KitSafety glassesHand hammer, 16 ouncesSocket wrench set, 3/8 inch driveNo. 2 Common Organizational Maintenance Tool KitTorque wrench, 3/8 inch drive, 200 lb-in capacityAutomotive Mechanic-s Tool KitDrive pin punch, 1/8 inch pointMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)REFERENCE: TM 5-3805-262-20NOTEPRELIMINARY PROCEDURE: Electrical wires and cables and hoses, lines andfittings disconnected from auxiliary steering pump and motor (refer toTM 5-3805-262-20).REMOVALAuxiliary steering pump and motor (4) is heavy. Be sure pump and motoris adequately supported before removing mounting hardware. Failure to doso could result in severe injury due to pump and motor falling andcrushing your foot.If you are injured by falling equipment, obtainmedical aid immediately.(1)(2)(3)At front left side of rear chassis,support auxiliary steering pump andmotor (4).Note location of ground cable on onecapscrew (1), then remove fourcapscrews (1), nuts (2), and lockwashers (3). Disconnect ground cablefrom capscrew (1) and remove.Remove pump and motor (4) from rearchassis.LEGEND1.2.3.4.Capscrews (4)Nuts (4)Lock washers (4)Auxiliary steeringpump and motor3-531
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business