TM 5-3805-262-34
3-14. STEERING GEAR MAINTENANCE (CONT)
INSTALLATION
a.
Put steering gear and steering column assembly in soft jawed vise. Slide
mounting plate (11) over steering column.
b.
Install and tighten two lock washers (10) and capscrews (9).
c.
Put steering gear and steering column in cab and position on deck. If neces-
sary, move floor mat out of position.
d.
Install and tighten four washers (8), lock washers (7), and capscrews (6) to
secure mounting plate to cab deck.
e.
Reinstall transmission control lever and mounting bracket (refer to TM 5-
3805-262-20).
f.
Slide support bearing (5) over top of steering column. Install and tighten
two washers (2), capscrews (1), lock washers (4), and nuts (3) to secure.
g.
h.
i.
j.
k.
Position cover on steering column and
over transmission control lever mounting
bracket. Secure cover using two screws.
Reinstall turn signal switch (refer to
TM 5-3805-262-20).
Position floor mat over mounting plate
(11).
Install steering wheel and connect
hoses, lines, and fittings to steering
gear (refer to TM 5-3805-262-20).
Start engine and check steering system
operation.
3-524
