TM 5-3805-262-343-22. CONTROL VALVE ASSEMBLY MAINTENANCE (CONT)b. Lift Spool (Cont).DISASSEMBLY ( SHEET 2 OF 4)( 2 )Put control valve(3) Using an open endassembly on clean work bench.wrench, loosen and remove seal assembly (1).( 4)Using a screwdriver, remove wiper (2) from seal assembly (1). Discardwiper.(5)Remove O-ring (3) from seal assembly (1). Discard O-ring.Don't overtighten vise in following step. TO do so will cause damage tocontrol valve body.(6)(7)( 8)( 9)(10)(11)(12)(13)Put control valve assembly ina soft jawed vise.Loosen detent housing (18).Install rod or small prybar inspool eyes as shown.Loosen and remove four screws(4).Pull connector (6) up from cap(9) just enough to gain accessto wires soldered to itscontacts. Tag and unsolderwires from connector (6) con-tacts. Remove connector.Remove setscrew (7).Using screwdriver, remove retaining ring (8). Then, remove cap (9).Remove and discard O-ring (10) from cap.On some units, tape may(12) together, preventingcannot remove coil (11)go to step (15) below.(14) Remove coil (11) andNOTEbe used to hold coils (11 and 15) and spacerremoval of coil (11) and spacer (12). If youand spacer (12), disregard step (14) below andspacer (12) from detent housing (18).3-662
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business