TM 5-3805-290-10
AIR TRANSPORT BY C-130 AND C-141 AIRCRAFT - CONTINUED
0026 00
UNLOAD MACHINE
00026 00
1.
Unload shipping pallet with ROPS/FOPS and exhaust stack from aircraft and place in a staging area clear of aircraft.
2.
Remove tiedowns from ROPS/FOPS, exhaust stack, and shipping pallet.
3.
Remove blocking and tiedowns from machine.
4.
Remove vandalism protection devices.
WAR N I N G
DO NOT operate machine with steering frame lock connected. Steering frame lock must be discon-
nected and securely stowed. If not properly stowed, loss of steering control could result. Failure to fol-
low this warning may result in injury or death to personnel or damage to equipment.
5.
Disconnect and securely stow steering frame lock (WP 0015 00).
6.
Turn battery disconnect switch to ON position (WP 0004 00).
WARN I N G
Stand clear of frame articulation area when machine is operating. There is no clearance for personnel
in this area when machine turns. Crushing could occur, resulting in injury or death to personnel.
7.
Start engine and allow to warm up (WP 0005 00).
8.
Press bottom of hydraulic lockout (IMPLEMENT DISABLE) switch to unlock hydraulic controls (WP 0004 00).
9.
Raise loader arm as required so that loader arm and work tool will clear crest of aircraft ramp (WP 0004 00). Remove
blocking from under work tool.
WAR N I N G
Always use a ground guide when operating machine down ramp to unload from aircraft. Failure
to use a ground guide may cause injury or death to personnel or damage to equipment.
When operating machine without ROPS/FOPS, drive with extreme caution, at low idle, and in 1st
gear forward ONLY. Machine has no rollover/falling object protection without ROPS/FOPS. Fail-
ure to follow this warning may cause injury or death to personnel or damage to equipment.
Using ground guide assistance and in 1st gear forward ONLY, SLOWLY drive straight off aircraft until clear of ramp.
10.
11.
Park machine in staging area clear of aircraft (WP 0005 00).
00026 00
RETURN MACHINE TO OPERATIONAL CONFIGURATION
Refer to WP 0028 00.
END OF WORK PACKAGE
0026 00-3/(0026 00-4 Blank)