TM 5-3805-290-10
CONFIGURE MACHINE FOR TRANSPORT - CONTINUED
0028 00
INTRODUCTION - CONTINUED
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure any lifting equipment used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting equipment. Failure to follow this warning may result in
death or injury to personnel.
3.
Components removed and installed during this procedure are very heavy. Use assistance, caution, and follow safe work
practices when handling them. Lifting equipment available at the staging area must be used.
0028 00
TOOLS AND EQUIPMENT
1.
Tools and equipment required to configure the machine for transport are:
a.
stowed in toolbox located behind operator's seat (Table 2, WP 0030 00),
b.
provided by Unit Maintenance (general mechanic's tool kit, common no. 1 shop equipment, P/N 162-8718 torque
wrench, and 400-lb capacity nylon strap); and
c.
1,650-lb capacity lifting equipment.
2.
Reinstall mounting hardware for all removed components on machine, to secure against loss during transport.
0028 00
EXHAUST STACK REMOVAL
1.
Turn battery disconnect switch to OFF position (WP 0004 00).
2.
Remove fire extinguisher and secure.
