TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1402 03
427-B1881
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1402 FMI 03 is active before per-
forming this procedure.
1. If each resistance measurement is
1. Check clutch 2 (forward high) solenoid
greater than 5,000 Ohms, go to Test 2.
energize circuit for a short to +battery circuit.
2. If each resistance measurement is not
(a) Turn engine start switch and battery
greater than 5,000 Ohms, there is a
disconnect switch to OFF position (TM
short between J1-62 (751 GN) and
circuit resistance measurement.
(b) Disconnect wiring harness connectors
Replace wiring harness in question
from clutch 2 (forward high) solenoid
(WP 0169 00 thru WP 0175 00).
and ECM.
(c) At ECM wiring harness connector,
measure resistance from contact J1-62
(wire 751 GN) to all contacts used in
ECM wiring harness connectors.