TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1401 03
427-B1880
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1401 FMI 03 is active before per-
forming this procedure.
1. If each resistance measurement is
1. Check clutch 1 (forward low) solenoid
greater than 5,000 Ohms, go to Test 2.
energize circuit for a short to +battery circuit.
2. If each resistance measurement is not
(a) Turn engine start switch and battery
greater than 5,000 Ohms, there is a
disconnect switch to OFF position (TM
short between J1-65 (752 YL) and
circuit that has a low resistance
(b) Disconnect wiring harness connectors
measurement. Replace wiring harness
from clutch 1 (forward low) solenoid
in question (WP 0169 00 thru WP 0175
(WP 0177 00) and machine ECM (WP
00).
0052 00).
(c) At ECM wiring harness connector,
measure resistance from contact J1-65
(wire 752 YL) to all contacts that are
used in ECM wiring harness
connectors.