TM 5-3805-290-23-2
MECHANICAL GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0023 00
TAGGING INSTRUCTIONS - CONTINUED
00023 00
3.
Identify fuel, oil, coolant, and hydraulic lines when you are taking off more than one line at the same time. Mark tags
with points to which lines and hoses must be connected. If it is not obvious which end of a line goes where, tag each end
of the line.
4.
Identify and tag other parts by name and installed location as required.
LINES AND PORTS
00023 00
To keep dirt from contaminating fluid systems when removing and installing fuel, oil, coolant, and hydraulic lines,
perform these steps:
a.
Clean fittings and surrounding area before disconnecting lines.
b.
Cover, cap, plug, or tape lines and ports after disconnecting lines. When these specialized covers are not available,
use plastic bags and rubber bands, clean rags, duct tape, or other similar materials to prevent dirt from entering
system.
c.
Ensure new and used parts are clean before installing.
d.
Replace all removed tiedown straps.
e.
Wait to remove covers, caps, plugs, or tape from lines and ports until just before installing lines.
00023 00
FLUID DISPOSAL
WARN I N G
When servicing equipment, performing maintenance, or disposing of materials such as engine
coolant, hydraulic fluid, lubricants, battery acids or batteries, and CARC paint, consult your
unit/local hazardous waste disposal center or safety office for local regulatory guidance. If further
information is needed, please contact The Army Environmental Hotline at 1-800-872-3845.
To prevent injury to personnel, wear protective eye covering and gloves.
Dispose of contaminated drained fluids in accordance with the Standard Operating Procedures (SOP) of your unit.
END OF WORK PACKAGE
0023 00-8
