TM 5-3805-290-23-2
IMPLEMENT HOSES, LINES, AND FITTINGS REPLACEMENT - CONTINUED
0131 00
WARN I N G
When servicing this machine, performing maintenance, or disposing of hazardous materials, consult
your unit/local hazardous waste disposal center or safety office for local regulatory guidance. If further
information is needed, please contact The Army Environmental Hotline at 1-800-872-3845.
DO NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down and
hydraulic system pressure has been relieved. Tighten all connections before applying pressure. Escap-
ing hydraulic fluid under pressure can penetrate the skin, causing injury to personnel.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulic lines. Failure to follow this warning may result in injury to personnel.
Lubricating/hydraulic oils used in the performance of maintenance can be very slippery. Immediately
wipe up any spills. Failure to follow this warning may result in injury to personnel.
To prevent injury to personnel, wear protective eye covering and gloves.
C AU T I O N
Wipe area clean around all connections to be opened during removal. Cap lines and hoses and plug open-
ings after removing lines. Contamination of system could result in premature failure.
N OT E
Use a container to catch any hydraulic oil that may drain from hoses or system. Dispose of oil IAW local
policy and ordinances. Ensure all spills are cleaned up.
REMOVAL
Bucket
1.
Disconnect hoses (1 and 2) from cylinder (3).
2.
Loosen clamp (4) and remove hose (2) from clamp
and machine.
3.
Remove and discard two O-rings (5).
4.
Remove bolt (6) and washer (7) from clamp (8) and
remove clamp from machine.
427-B1120
0131 00-2