TM 5-3805-290-23-2
CYLINDER HEAD REPLACEMENT - CONTINUED
0146 00
REMOVAL - CONTINUED
N OT E
If installing new cylinder head, remove the following items from old cylinder head and set aside for future
use.
9.
Remove six bolts (11) and two brackets (12) from cylinder head (7).
10.
Remove plug (13) and O-ring (14). Discard O-ring.
11.
If necessary, remove dowels (9) from cylinder head (7).
427-B1835
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make sure
air stream is directed away from user and other personnel in the area. To prevent injury, user must
wear protective goggles or face shield. Failure to follow this warning may result in injury to personnel.
1.
Clean all parts and mating surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
0146 00-5
