TM 5-3805-291-10
ENGINE AIR PRECLEANER SERVICE AND AIR CLEANER SERVICE - CONTINUED
0014 00
SERVICE - CONTINUED
1.
Tilt hood (WP 0004 00). Access air cleaner on right side of machine.
2.
Release three clamps and remove cover from air cleaner housing.
3.
Remove primary filter element from air cleaner housing.
4.
Remove secondary filter element from air cleaner housing. Cover air inlet opening with a rag.
427-C0003
5.
Clean inside of air cleaner housing with a rag.
CAU T I ON
DO NOT use a damaged primary filter element. Engine damage can result.
6.
Inspect primary filter element for damaged pleats, tears, holes, gaskets, and seals. Discard primary filter element if any
damage is evident. Obtain replacement from Unit Maintenance.
7.
If primary filter element appears OK, clean as follows:
WARN I N G
Particles blown by compressed air are hazardous. Use a maximum of 30 psi (207 kPa) when cleaning com-
ponents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury. Make sure air stream is directed away from user and other personnel in the area. To prevent injury,
user must wear protective goggles or face shield.
CAU T I ON
To prevent damage, DO NOT clean primary filter element by bumping or tapping.
DO NOT wash primary filter element.
a.
Direct compressed air inside primary filter element, from top to bottom along length of filter pleats.
Direct compressed air outside, from top to bottom along length of filter pleats.
b.
0014 00-2