TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(2) Measure resistance between connec- 1. If resistance is less than 5 Ohms, go to
0590 02 - Continued.
tor contact J1-20 (wire 945-BR) of
Test 6.
powertrain ECM and connector con- 2. If resistance is greater than 5,000 Ohms,
tact J1-9 (wire 945-BR) of engine
CAT Data Link circuit is open in wiring
ECM.
harness. Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
6. Check for additional diagnostic codes for
other ECMs.
(a) Reconnect all ECMs that use CAT Data
Link.
(b) Turn battery disconnect and engine
start switches to ON position (TM 5-
3805-291-10).
(c) After ECMs have been reconnected,
1. If diagnostic codes are not present for
check event list for diagnostic codes
other ECMs in event list, exit this
logged against the ECM.
procedure and repeat this procedure. If
failure is not found, replace engine ECM
(WP 0057 00).
2. If diagnostic codes are present for other
ECMs in event list, exit this procedure
and repeat this procedure again. If
failure is not found, replace powertrain
ECM (WP 0063 00).
0009 00-41
