TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1. If there is less than 5.0 Ohms resistance,
(d) Measure resistance between contact
0585 02 - Continued.
J1-2 and contact J1-3.
go to Test 3.
2. If there is more than 5,000 Ohms
resistance, there is an open circuit in
wiring harness (wire E900-WH or wire
E901-GN). Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
3. Check signal for a short.
(a) Remove jumper between contact 1 and
contact 2 of wiring harness connector
for speed sensor.
(b) Reconnect speed sensor to wiring
harness (WP 0093 00).
(c) At wiring harness connector J1,
measure resistance between contact J1-
2 and all possible sources of positive
voltage and at all possible sources of
ground.
(d) At wiring harness connector J1,
1. If resistance is greater than 5,000 Ohms,
measure resistance between contact J1-
go to Test 4.
3 and all possible sources of positive
2. If resistance is less than 5 Ohms, short
voltage and at all possible sources of
is between signal circuit (wire E900-
ground.
WH or wire E901-GN) and circuit with
low resistance. Replace wiring harness
in question (WP 0195 00 thru WP 0201
00).
4. Check if diagnostic code remains active.
(a) Clean wiring harness connector
contacts.
(b) Reconnect all wiring harness
connectors.
(c) Start engine and run engine at low idle
(TM 5-3805-291-10).
(d) Operate machine. Transmission must
be engaged in a direction, and in a
speed, and machine must be moving
(TM 5-3805-291-10).
0009 00-37