TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0585 02
427-C1625
1. Check resistance of sensor.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect wiring harness connector
from TOS Sensor 1 (leading) connector
(WP 0093 00).
(c) Measure resistance between contacts 1 1. If resistance is between 800 and 1,800
Ohms, go to Test 2.
and 2 of TOS Sensor 1 (leading)
connector.
2. If resistance is not between 800 and
1,800 Ohms, replace speed sensor.
Adjust speed sensor properly when
installing (WP 0093 00).
2. Check signal circuit for an open circuit in
wiring harness.
(a) Engine start and the battery disconnect
switches remain in OFF position (TM
5-3805-291-10).
(b) At wiring harness connector for speed
sensor, place a jumper between contact
1 and contact 2.
(c) Disconnect wiring harness connectors
J1 and J2 from powertrain ECM (WP
0063 00).