TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check solenoid energizer circuit for a short
2684 06 - Continued.
to ground.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Ride control solenoid valve #3 remains
disconnected from wiring harness.
(c) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(d) At wiring harness connector for ECM, 1. If each resistance measurement is
measure resistance from contact J2-3
greater than 5,000 Ohms, go to Test 3.
(wire A958-WH) to all contacts used in 2. If each resistance measurement is not
wiring harness connectors for ECM.
greater than 5,000 Ohms, short is
between signal circuit for ride control
solenoid valve #3 and circuit with low
resistance measurement. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
3. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all harness connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Check status of CID 2684 FMI 06.
1. If CID 2684 FMI 06 is active, exit this
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 2684 FMI 06 is not active,
problem does not exist at this time.
Resume normal machine operation.
0009 00-161
