TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(c) After disconnecting sensor(s),
1. If resistance is greater than 5,000 Ohms,
0041 04 - Continued.
check resistance from frame
wiring harness circuit resistance is
ground to contact J1-44 (sensor
correct. Sensor that was just
supply) of wiring harness
disconnected has failed. Replace sensor.
connector for implement ECM.
Refer to appropriate work package
2. If resistance is less than 5,000 Ohms after
all sensors have been disconnected from
wiring harness, wiring harness is shorted
to ground. Replace wiring harness in
question (WP 0195 00 thru WP 0201 00).
N OT E
0168 00
Ensure CID 0168 FMI 00 is active and diagnostic code indicator is
active.
1. Check charging system.
(a) Turn engine start switch to ON
position (TM 5-3805-291-10).
(b) Connect MSD (WP 0005 00) and
ensure CID 0168 FMI 00 is active.
(c) Ensure diagnostic code indicator is
1. If diagnostic code indicator is active, go
active.
to Test 3.
2. If diagnostic code indicator is not active,
go to Test 2.
2. Check charging system.
(a) Start engine (TM 5-3805-291-10).
(b) Ensure CID 0168 FMI 00 is active.
(c) Observe status of diagnostic code
1. If diagnostic code indicator is active,
indicator.
system is charging at an excessive
voltage. Check charging system (WP
2. If diagnostic code indicator is not active,
there is no problem at this time.