TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 4. Implement Control - Continued.
(MID 082)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check wiring harness.
0487 04 - Continued.
(a) Sensor remains disconnected.
(b) Turn battery disconnect switch to
OFF position (TM 5-3805-291-10).
(c) Disconnect wiring harness from
implement ECM (WP 0060 00).
(d) At wiring harness connector for
1. If resistance is greater than 5,000 Ohms,
implement ECM, measure
go to Test 3.
resistance between connector J2-26 2. If resistance is less than 5.0 Ohms,
(wire H722-GN) and ground.
harness has failed, replace wiring harness
in question (WP 0195 00 thru WP 0201
00).
3. Check +battery circuit.
(a) Ensure engine start switch is in OFF
position (TM 5-3805-291-10).
(b) Connector for sensor remains
disconnected. Connector for
implement ECM remains
disconnected.
(c) Measure resistance between fuse
1. If resistance is less than 5 Ohms, go to
and contact 1 at connector for
Test 4.
sensor.
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
4. Check ground circuit.
(a) Ensure engine start switch is in OFF
position (TM 5-3805-291-10).
(b) Connector for sensor remains
disconnected. Connector for
implement ECM remains
disconnected.
(c) Measure resistance between
1. If resistance is less than 5 Ohms, harness
contact J1-45 at connector for
circuit is correct. Ensure diagnostic code
implement ECM and contact 2 at
is still active. Exit this procedure and
connector for sensor.
repeat this troubleshooting procedure. If
cause of diagnostic code is not found,
replace implement ECM (WP 0060 00).
2. If resistance is greater than 5 Ohms,
replace wiring harness in question (WP
0195 00 thru WP 0201 00).
0009 00-237
