TM 5-3805-291-23-1
POWERTRAIN TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0014 00
TRANSMISSION NEUTRALIZATION SETPOINT ADJUSTMENT - CONTINUED
12.
Exit calibrations.
13.
Close MSD.
14.
Disconnect MSD from diagnostic connector (WP 0005 00).
15.
Stop engine (TM 5-3805-291-10).
16.
Release hydraulic system pressure (TM 5-3805-291-10).
17.
Remove test stand from pressure tap (25) of service brake control valve (26).
427-C0748
0014 00
SPEED SENSOR ADJUSTMENT
1.
Loosen locknut (32) on torque converter speed sensor (33).
2.
Remove torque converter speed sensor (33) (WP 0091 00).
3.
Align gear tooth (34) directly in center of threaded sensor opening.
4.
Screw speed sensor (33) into hole by hand until end of sensor contacts gear tooth (34).
5.
Turn speed sensor (33) counterclockwise 1/2 turn to set air gap (A) to 0.028 in. (0.71 mm).
N OT E
Do not allow speed sensor to turn as locknut is tightened.