TM 5-3805-291-23-1
HYDRAULIC SYSTEM TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0017 00
JOYSTICK CONTROL POSITION SENSOR CALIBRATION WITH MSD - CONTINUED
13.
Turn engine start switch to OFF position. (TM 5-3805-291-10).
14.
Disconnect MSD from diagnostic connector (WP 0005 00).
LIFT AND TILT LINKAGE POSITION SENSOR (MSD) CALIBRATION
0017 00
N OT E
This calibration procedure will set signal limits for implement postion sensors. Signal limits are
i
maximum and minimum duty cycles that are sent from position sensors to implement ECM.
Joystick sensors are factory calibrated and shoud not require calibration. However, calibration
l
may be necessary if problems exist activating detents.
Up arrow refers to LOWER position. Down arro refers to RAISE position. Right arrow refers
w
to DUMP position. Left arrow refers to TILT BACK position.
For auxiliary control, up arrow refers to au iliary lever in FORWARD position. Down arrow
x
refers to auxiliary lever in REARWARD position.
For additional information on joystick control, refer to TM 5-3805-291-10.
1.
Connect MSD to diagnostic connector (WP 0005 00).