TM 5-3805-291-23-1
HYDRAULIC SYSTEM TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0017 00
IMPLEMENT HYDRAULIC SERVICE MODE
0017 00
WARN I N G
If machine is in Implement Hydraulic Service Mode and work tool is off ground, do not place control levers
in FLOAT position. Placing levers in FLOAT position will cause work tool linkage to immediately fall.
Injury or death to personnel can result from falling work tool linkage.
N OT E
Service mode for implement hydraulics is usedfor certain testing and adjustment procedures.
Only basic functions of lift and tilt circuits will operate in this mode.
All advanced implement control features will be disabled in service mode. Kickouts, cylinder
snubbing, and dump rate control are features of implement control that will be disabled.
1.
Connect MSD to diagnostic connector (WP 0005 00).
2.
Start and run engine at low idle (TM 5-3805-291-10).
3.
Select "Implement" (1) from "ECM Selector" screen and click "OK" (2).
427-C0785