TM 5-3805-291-23-2
TRANSMISSION OIL FILLER TUBE REPLACEMENT - CONTINUED
0103 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and mating surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
4.
Inspect oil passages to ensure they are clean and unobstructed.
INSTALLATION
1.
Install new gasket (4), plate (3), ball (2), and cap (1) on upper filler tube (6).
2.
Install new gasket (9), lower filler tube (10), four washers (8), and bolts (7) on machine.
3.
Install hose (12) on lower filler tube (10).
4.
Install upper tube (6) in hose (12)
5.
Install two clamps (5), washers (14), and bolts (13) on upper filler tube (6) and battery box (15).
6.
Tighten two clamps (11) on hose (12).
7.
Fill transmission with oil (WP 0100 00).
8.
Start engine (TM 5-3805-291-10).
9.
Shut off engine and check for leaks.
END OF WORK PACKAGE
0103 00-3/(0103 00-4 Blank)