TM 5-3805-291-23-2
TRANSMISSION OIL FILTER BASE, LINES, AND BYPASS SWITCH REPLACEMENT - CONTINUED 0104 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for damage, wear, pitting, cracks, or corrosion and replace if necessary.
INSTALLATION
N OT E
Apply a thin coat of clean oil to all O-rings before installation.
1.
Install new O-ring (53), line (39), two flanges (52), four washers (51), and bolts (50) on transmission (49).
2.
Install new O-ring (48), line (38), two flanges (47), four washers (46), and bolts (45) on transmission (49).
3.
Position elbow (34) on bracket (43).
4.
Install nut (44) on elbow (34).
5.
Position elbow (32) on bracket (43).
6.
Install nut (42) on elbow (32).
7.
Install new O-ring (41) and line (39) on elbow (34).
8.
Install new O-ring (40) and line (38) on elbow (32).
9.
Install two clamps (37), washer (36), and bolt (35) on lines (39 and 38).
10.
Install new O-ring (33) and hose (13) on elbow (34).
11.
Install new O-ring (31) and hose (6) on elbow (32).
12.
Install two clamps (30), washer (29), and bolt (28) on hoses (13 and 6).
0104 00-5