TM 5-3805-291-23-2
SERVICE BRAKE CONTROL VALVE REPLACEMENT - CONTINUED
0116 00
N OT E
Tag hoses prior to removal to ensure correct installation.
Use a container to catch any fluid that may drain from hoses or system. Dispose of fluid IAW local pol-
icy and ordinances. Ensure all spills are cleaned up.
REMOVAL
1.
Disconnect five hose assemblies (1) and remove O-rings (2) from fitting assemblies (3). Discard O-rings.
2.
Remove two nuts (4), washers (5), and control valve (6) from machine.
N OT E
Note position of fitting assemblies before removal to aid in installation.
3.
Remove five fitting assemblies (3) from control valve (6).
4.
Remove and discard five O-rings (7) from fitting assemblies (3).
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and mating surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
0116 00-2
