TM 5-3805-291-23-2
SECONDARY STEERING PUMP AND ELECTRIC MOTOR MAINTENANCE - CONTINUED
0123 00
DISASSEMBLY
1.
Remove four bolts (10), washers (11), and bracket
(12) from electric motor (4).
2.
Remove two fittings (15) from secondary steering
pump (6).
3.
Remove two bolts (13), washers (14), secondary steer-
ing pump (6), and gasket (16) from electric motor (4).
Discard gasket.
427-C0525
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and mating surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
4.
Inspect oil passages to ensure they are clean and unobstructed.
ASSEMBLY
C AU T I O N
Wipe area clean around all connections to be opened during removal. Cap lines and hoses and plug open-
ings after removing lines. Contamination of system could result in premature failure.
1.
Install new gasket (16) between secondary steering pump (6) and electric motor (4) and install two washers (14) and
bolts (13).
2.
Install two fittings (15) on secondary steering pump (6).
3.
Position bracket assembly (12) on electric motor (4) and install four washers (11) and bolts (10).
0123 00-3
