6
TM 5-3805-291-23-2
BRAKE CHARGE AND HYDRAULIC FAN CONTROL MANIFOLD REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Materials/Parts - Continued
Direct Support
Tools and Special Tools
O-ring (14)
Tool kit, general mechanic's, automotive (Item 90,
Personnel Required
MOS 62B, Construction Equipment Repairer
Shop equipment, automotive maintenance and
repair: field maintenance, basic, less power (Item
Equipment Conditions
Hydraulic system pressure relieved (TM 5-3805-
Materials/Parts
291-10)
Steering frame lock connected (TM 5-3805-291-
10)
Cleaning compound, solvent, type III (Item 7, WP
Hood opened (TM 5-3805-291-10)
Oil, lubricating, OE/HDO-5/40 (Item 27, WP 0233
00)
Drawings Required
Oil, lubricating, OE/HDO-15/40 (Item 28, WP
TM 5-3805-291-23P, Figure 147
Estimated Time to Complete Task
Oil, lubricating, OEA-30, Arctic (Item 29, WP
2.0 hr
WARN I N G
When servicing this machine, performing maintenance, or disposing of materials such as engine cool-
ant, hydraulic fluid, lubricants, battery acids or batteries, and CARC paint, consult your unit/local
hazardous waste disposal center or safety office for local regulatory guidance. If further information is
needed, please contact The Army Environmental Hotline at 1-800-872-3845.
DO NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down and
hydraulic system pressure has been relieved. Tighten all connections before applying pressure.
Escaping hydraulic fluid under pressure can penetrate the skin, causing injury to personnel.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any
hydraulic lines. Failure to follow this warning may result in injury to personnel.
Hydraulic oils used in performance of maintenance can be very slippery. Immediately wipe up any
spills. Failure to follow this warning may result in injury to personnel.