TM 5-3805-291-23-2
BUCKET TILT LEVER AND LINK REPLACEMENT - CONTINUED
0228 00
INSTALLATION
Tilt Lever
0228 00
N OT E
Before installation, lubricate bore, pins, and lip seals with grease cartridge.
1.
Lower temperature of bearing (27) for tilt lever (17).
2.
Using puller assembly, install bearing (27) in tilt lever
(17) to a depth of 0.39 0.04 in. (10.0 1.0 mm).
427-C1138
3.
Use bushing driver set to install new lip seal (26) in side of tilt lever (17). Make sure lip of seal is facing out.
4.
Repeat step 3 for lip seal (26) on opposite side of tilt lever (17).
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting equipment used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting equipment. Failure to follow this warning may result in injury
or death to personnel.
0228 00-10