TM 5-3805-292-23
0045
CLEANING AND INSPECTION CONTINUED
WARN I N G
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa)
nozzle pressure when drying parts with compressed air. DO NOT direct compressed air
against human skin. Make sure air stream is directed away from user and other personnel
in the area. To prevent injury, user must wear protective goggles or face shield. Failure to
follow this warning may result in injury to personnel.
3. Dry parts with compressed air.
4. Inspect parts for wear, pitting, cracks, or corrosion and replace if necessary.
END OF TASK
INSTALLATION
00045
1. Install new gasket (Figure 1, Item 6), manifold (Figure 1, Item 1), and seven bolts (Figure 1, Item 4) on engine
(Figure 1, Item 2).
2. Torque seven bolts (Figure 1, Item 4) to 22 ft lb 5 lb-ft (30 5 Nm).
3. Connect line (Figure 1, Item 3) to engine.
WARN I N G
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can
cause lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety
goggles and use product in a well-ventilated area away from open flame. If ingested, keep
individual calm and seek medical attention. DO NOT induce vomiting. If contact with skin
or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW local policy
and ordinances. Failure to follow this warning may result in injury to personnel.
4. Apply sealing compound to bolt (Figure 1, Item 5) and install on engine.
END OF TASK
FOLLOW-ON TASKS
00045
1. Install engine air duct heater (WP 0029).
2. Install muffler and pipes (WP 0018).
3. Close ROPS (WP 0134).
4. Verify correct operation of machine (TM 5-3805-292-10).
END OF TASK
END OF WORK PACKAGE
0045-3/(4 blank)