TM 5-3805-292-23
0048
CLEANING AND INSPECTION
00048
1. Remove all gasket material from mating surfaces.
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and
low toxic material. However, it may be irritating to the eyes and skin. Use protective gloves
and goggles. Use in well-ventilated areas. Keep away from open flames and other
sources of ignition. Failure follow this warning may result in injury or death to personnel.
2. Clean all parts (except rubber and plastic surfaces) and mating surfaces with solvent cleaning compound.
WARN I N G
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa)
nozzle pressure when drying parts with compressed air. DO NOT direct compressed air
against human skin. Make sure air stream is directed away from user and other personnel
in the area. To prevent injury, user must wear protective goggles or face shield. Failure to
follow this warning may result in injury to personnel.
3. Dry parts with compressed air.
4. Inspect parts for wear, pitting, cracks, or corrosion and replace if necessary.
END OF TASK
INSTALLATION
00048
1. Install new gasket (Figure 1, Item 16), turbocharger (Figure 1, Item 3), four washers (Figure 1, Item 2), and
nuts (Figure 1, Item 1) on machine.
2. Install new gasket (Figure 1, Item 10), oil return pipe (Figure 1, Item 11), and two bolts (Figure 1, Item 9) on
machine.
3. Install bolt (Figure 1, Item 12) on clamp (Figure 1, Item 13) of oil return pipe (Figure 1, Item 11).
4. Position oil delivery pipe (Figure 1, Item 15) on machine and tighten fitting (Figure 1, Item 14).
5. Install new seal (Figure 1, Item 6), oil delivery pipe (Figure 1, Item 15), new seal (Figure 1, Item 5), and bolt
(Figure 1, Item 4) on machine.
6. Install hose (Figure 1, Item 7) and two clamps (Figure 1, Item 8) on machine.
END OF TASK
FOLLOW-ON TASKS
00048
1. Install air cleaner hoses (WP 0058).
2. Install muffler and pipes (WP 0018).
3. Close ROPS (WP 0134).
4. Verify correct operation of machine (TM 5-3805-292-10).
END OF TASK
END OF WORK PACKAGE
0048-3/(4 blank)
