TM 5-3805-292-23
0150
CLEANING AND INSPECTION
000150
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and
low toxic material. However, it may be irritating to the eyes and skin. Use protective gloves
and goggles. Use in well-ventilated areas. Keep away from open flames and other
sources of ignition. Failure follow this warning may result in injury or death to personnel.
1. Clean all parts (except rubber and plastic surfaces) and mating surfaces with solvent cleaning compound.
WARN I N G
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa)
nozzle pressure when drying parts with compressed air. DO NOT direct compressed air
against human skin. Make sure air stream is directed away from user and other personnel
in the area. To prevent injury, user must wear protective goggles or face shield. Failure to
follow this warning may result in injury to personnel.
2. Dry parts with compressed air.
3. Inspect parts for wear, pitting, cracks, or corrosion and replace if necessary.
END OF TASK
INSTALLATION
000150
1. Install inserts (Figure 1, Item 3), new gasket (Figure 1, Item 6), sender (Figure 1, Item 1), and five screws (Fig-
ure 1, Item 2) on machine.
N OT E
Install wires as tagged during removal.
2. Install two wires (Figure 1, Item 5), connector (Figure 1, Item 7), and nuts (Figure 1, Items 4 and 8) on sender
(Figure 1, Item 1).
END OF TASK
FOLLOW-ON TASKS
000150
1. Connect battery power (WP 0142).
2. Verify correct operation of machine (TM 5-3805-292-10).
END OF TASK
END OF WORK PACKAGE
0150-3/(4 blank)