TM 5-3805-292-23
0151
CLEANING AND INSPECTION
000151
Clean and inspect all parts IAW Electrical General Maintenance Instructions (WP 0173).
END OF TASK
INSTALLATION
000151
N OT E
Install wires and connectors as tagged during removal.
Install tiedown straps.
1. Connect fuel injection pump harness (Figure 1, Item 8) to engine.
2. Install connector (Figure 1, Item 10) on fuel injection pump (Figure 1, Item 4) and connect engine wiring
harness (Figure 1, Item 9) to connector (Figure 1, Item 10).
3. Install wire (Figure 1, Item 6) and nut (Figure 1, Item 5) on fuel injection pump (Figure 1, Item 4). Position
rubber boot (Figure 1, Item 7) over wire (Figure 1, Item 6).
4. Install wire (Figure 1, Item 2) and nut (Figure 1, Item 1) on fuel injection pump (Figure 1, Item 4). Position
rubber boot (Figure 1, Item 3) over wire (Figure 1, Item 2).
END OF TASK
FOLLOW-ON TASKS
000151
1. Connect battery power (WP 0142).
2. Close ROPS (WP 0134).
3. Verify correct operation of machine (TM 5-3805-292-10).
END OF TASK
END OF WORK PACKAGE
0151-3/(4 blank)