TM 5-3805-298-23-1
0018
Table 1. E0236 Return Hydraulic Oil Filter Plugged Event Code - Continued.
018
EID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 1. Check for Active
E0236 Return Hydraulic Oil
Diagnostic Codes.
Filter Plugged Event Code -
1. Connect MSD (WP 0008) and
Continued
select Transmission 924H.
2. Start and run engine (TM 5-3805-
298-10).
3. Using MSD (WP 0008), check for
Diagnostic Codes Are Not Active -
active diagnostic codes.
Proceed to Test Step 2.
Diagnostic Codes Are Active - Refer
to (WP 0005) and repair active
diagnostic codes first.
Test Step 2. Hydraulic Oil Filter Test.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-298-10).
2. Replace hydraulic oil filter
(WP 0385).
3. Turn battery disconnect switch to
ON position (TM 5-3805-298-10).
4. Start and idle engine until normal
operating temperature (hydraulic
oil 110F) is reached (TM 5-3805-
298-10).
5. Using MSD (WP 0008), verify
Event Code E0236 Not Active -
event code E0236 is not active.
Troubleshooting complete.
Event Code E0236 Is Active - Proceed
to Test Step 3.
0018-3