TM 5-3805-298-23-1
0071
Table 1. Transmission Does Not Operate in Any Gear - Continued.
071
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 8. Test Rear Axle.
Transmission Does Not
1. Turn the transmission control to
Operate in Any Gear -
Neutral (N) (TM 5-3805-298-10).
Continued
2. Apply parking brake (TM 5-3805-
298-10).
3. Turn ignition switch to OFF
position (TM 5-3805-298-10).
4. Install rear drive shaft (WP 0318).
5. Start engine (TM 5-3805-298-10).
6. Raise the work tool above the
ground (TM 5-3805-298-10).
7. Turn transmission neutralizer
switch to ON (TM 5-3805-298-10).
8. Warm the transmission oil to
normal operating temperature of
approximately 165F to 185F
(75C to 85C).
9. Warm the hydraulic oil to operating
temperature of 140F (60C)
(TM 5-3805-298-10).
10. Apply service brake and release
parking brake (TM 5-3805-298-
10).
11. Turn the transmission control to
first speed forward (TM 5-3805-
298-10).
12. Check that the path forward is
clear to allow machine to move
and release service brake
(TM 5-3805-298-10).
13. Make note if machine moves
Machine Moves Forward - Replace
forward. Turn the transmission
front axle (WP 0320).
control to Neutral (N) (TM 5-3805-
Proceed to Test Step 10.
298-10). Apply parking brake
Machine Does Not Move Forward -
(TM 5-3805-298-10). Turn ignition
Replace rear axle (WP 0322).
switch to OFF position
Proceed to Test Step 10.
(TM 5-3805-298-10).
0071-9