TM 5-3805-298-23-1
0092
Table 1. 444 Start Relay Diagnostic Codes - Continued.
092
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
6. Start engine (TM 5-3805-298-10).
444-5 Start Relay Current
7. Using MSD, check for active
Below Normal - Continued
Diagnostic Code 444-6 Start Relay
diagnostic codes (WP 0008).
Current Above Normal Becomes
Active - Replace starter relay (WP
0262).
Proceed to Test Step 5.
Diagnostic Code 444-5 Start Relay
Current Below Normal Remains
Active - Proceed to Test Step 3.
Test Step 3. Test Lower Cab Wiring
Harness for High Resistance or
Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove left lower cab access
panels (WP 0347).
3. Remove transmission ECM cover
(WP 0266).
4. Disconnect connector C-C13
WP 0012, Figure 25) from
Transmission ECM J2.
5. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Replace transmission ECM (WP 0266).
between connector C-C13
Proceed to Test Step 5.
(WP 0012, Figure 25) terminal 7
Resistance Greater Than 5.0 Ohms -
and terminal 8.
Proceed to Test Step 4.
0092-5