TM 5-3805-298-23-1
0107
Table 1. 826 Torque Converter Oil Temperature Sensor Diagnostic Codes - Continued.
0107
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3. Using digital multimeter
Continuity - Replace transmission
826-4 Torque Converter Oil
(WP 0174), test for continuity
wiring harness (WP 0298).
Temperature Sensor Voltage
between connector P-C1
Is Below Normal or Shorted
Proceed to Test Step 5.
(WP 0012, Figure 53) terminal 22
Low - Continued
No Continuity - Proceed to step 4.
and terminal 19.
4. Using digital multimeter
Continuity - Replace transmission
(WP 0174), test for continuity
wiring harness (WP 0298).
between connector P-C1
Proceed to Test Step 5.
(WP 0012, Figure 53) terminal 22
No Continuity - Proceed to Test
and ground.
Step 4.
Test Step 4. Test for Shorted Lower
Cab Wiring Harness.
1. Remove transmission ECM cover
(WP 0266).
2. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
3. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C12
Proceed to Test Step 5.
(WP 0012, Figure 26) terminal 29
No Continuity - Proceed to step 4.
and terminal 13.
4. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C12
Proceed to Test Step 5.
(WP 0012, Figure 26) terminal 29
No Continuity - Replace transmission
and ground.
ECM (WP 0266).
Proceed to Test Step 5.
Test Step 5. Verify Malfunction Is
Resolved.
1. Ensure all wiring harness
connectors are connected.
2. Install left engine access panel
(WP 0350).
3. Install transmission ECM cover
(WP 0266).
4. Install left and right lower cab
access panels (WP 0347).
0107-7