TM 5-3805-298-23-1
0108
Table 1. 882 Implement Lockout Solenoid Diagnostic Codes - Continued.
0108
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3. Turn battery disconnect switch and
882-6 Implement Lockout
ignition switch to ON position
Solenoid Current Above
(TM 5-3805-298-10).
Normal - Continued
4. Using MSD, check for active
Diagnostic Code 882-5 Implement
diagnostic codes (WP 0008).
Lockout Solenoid Current Below
Normal Becomes Active - Replace
hydraulic lock-out valve and solenoid
(WP 0375).
Proceed to Test Step 4.
Diagnostic Code 882-6 Implement
Lockout Solenoid Current Above
Normal Remains Active - Turn ignition
switch and battery disconnect switch to
OFF position (TM 5-3805-298-10).
Proceed to Test Step 3.
Test Step 3. Test for Shorted Lower
Cab Wiring Harness.
1. Remove left lower cab access
panels (WP 0347).
2. Remove transmission ECM cover
(WP 0266).
3. Disconnect connector C-C13
(WP 0012, Figure 25) from
Transmission ECM J2.
4. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C13
Proceed to Test Step 4.
(WP 0012, Figure 25) terminal 2
No Continuity - Proceed to step 5.
and terminal 4.
5. Using digital multimeter
Continuity - Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C13
Proceed to Test Step 4.
(WP 0012, Figure 25) terminal 2
No Continuity - Replace transmission
and ground.
ECM (WP 0266).
Proceed to Test Step 4.
Test Step 4. Verify Malfunction Is
Resolved.
1. Ensure all wiring harness
connectors are connected.
2. Install transmission ECM cover
(WP 0266).
3. Install left lower cab access panels
(WP 0347).
0108-7