TM 5-3805-298-23-1
0108
Table 1. 882 Implement Lockout Solenoid Diagnostic Codes - Continued.
0108
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. Remove left lower cab access
882-5 Implement Lockout
panels (WP 0347).
Solenoid Current Below
3. Remove transmission ECM cover
Normal - Continued
(WP 0266).
4. Disconnect connector C-C13
(WP 0012, Figure 25) from
Transmission ECM J2.
5. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Replace transmission ECM (WP 0266).
between connector C-C13
Proceed to Test Step 4.
(WP 0012, Figure 25) terminal 2
Resistance Greater Than 5.0 Ohms -
and terminal 4.
Replace lower cab wiring harness
(WP 0291).
Proceed to Test Step 4.
Test Step 4. Verify Malfunction Is
Resolved.
1. Ensure all wiring harness
connectors are connected.
2. Install transmission ECM cover
(WP 0266).
3. Install left lower cab access panels
(WP 0347).
4. Using MSD, check for active
Diagnostic Code 882-5 Implement
diagnostic codes (WP 0008).
Lockout Solenoid Current Below
Normal Becomes Inactive -
Troubleshooting complete.
Diagnostic Code 882-5 Implement
Lockout Solenoid Current Below
Normal Remains Active - Repeat
troubleshooting from the beginning.
0108-5