TM 5-3805-298-23-1
0111
Table 1. 1402 Solenoid Valve 2 (Forward High) Diagnostic Codes - Continued.
0111
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
6. Turn transmission control lever to
1402-6 Solenoid Valve 2
4 and push to F (forward) position
(Forward High) Current
(TM 5-3805-298-10).
Above Normal - Continued
7. Using MSD, check for active
Diagnostic Code 1402-5 Solenoid
diagnostic codes (WP 0008).
Valve 2 (Forward High) Current
Below Normal Becomes Active
Replace clutch solenoid valve 2
(forward high) (WP 0310).
Proceed to Test Step 5.
Diagnostic Code 1402-6 Solenoid
Valve 2 (Forward High) Current
Above Normal Remains Active
Proceed to Test Step 3.
Test Step 3. Test for Shorted
Transmission Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector P-C1
(WP 0012, Figure 53) from
connector C-C15 (WP 0012,
Figure 52).
3. Using digital multimeter
Continuity Replace transmission
(WP 0174), test for continuity
wiring harness (WP 0298).
between connector P-C1
Proceed to Test Step 5.
(WP 0012, Figure 53) terminal 11
No Continuity Proceed to step 4.
and terminal 27.
4. Using digital multimeter
Continuity Replace transmission
(WP 0174), test for continuity
wiring harness (WP 0298).
between connector P-C1
Proceed to Test Step 5.
(WP 0012, Figure 53) terminal 11
No Continuity Proceed to Test
and ground.
Step 4.
Test Step 4. Test for Shorted Lower
Cab Wiring Harness.
1. Remove left lower cab access
panels (WP 0347).
2. Remove transmission ECM cover
(WP 0266).
3. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
4. Using digital multimeter
Continuity Replace lower cab wiring
(WP 0174), test for continuity
harness (WP 0291).
between connector C-C12
Proceed to Test Step 5.
(WP 0012, Figure 26) terminal 62
No Continuity Proceed to step 5.
and terminal 60.
0111-8