TM 5-3805-298-23-2
0134
Table 1. One or Both Front Work Lights Do Not Operate - Continued.
0134
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. Using digital multimeter
One or Both Front Work
Voltage 18 to 24 V Replace front RH
(WP 0174), test for voltage
Lights Do Not Operate -
work light (WP 0271).
between connector FE-C7
Continued
Proceed to Test Step 31.
(WP 0012, Figure 175) terminal 1
Voltage Less Than 18 V Replace
and terminal 2 (ground).
work light wiring harness (WP 0300).
Proceed to Test Step 31.
Test Step 3. Test for Voltage at Front
LH Work Light.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Disconnect connector FE-C8
(WP 0012, Figure 173) from front
LH work light (WP 0012,
Figure 174).
3. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
4. Using digital multimeter
Voltage 18 to 24 V Replace front LH
(WP 0174), test for voltage
work light (WP 0271).
between connector FE-C8
Proceed to Test Step 31.
(WP 0012, Figure 173) terminal 1
Voltage Less Than 18 V Replace
and terminal 2 (ground).
work light wiring harness (WP 0300).
Proceed to Test Step 31.
Test Step 4. Test for Open Lamps
Fuse.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Remove lamps fuse from fuse
panel (TM 5-3805-298-10).
3. Using digital multimeter
Resistance 5.0 Ohms or Less Install
(WP 0174), measure resistance
lamps fuse (TM 5-3805-298-10) and
between terminals of lamps fuse.
proceed to Test Step 5.
Resistance Greater Than 5.0 Ohms
Replace lamps fuse (TM 5-3805-298-
10) and proceed to Test Step 18.
0134-3