TM 5-3805-298-23-4
0389
CLEANING AND INSPECTION
000389
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0172).
END OF TASK
INSTALLATION
000389
NOTE
Install wiring harness connectors and route wiring harness as noted during removal.
1. Install new O-ring (Figure 2, Item 2) on primary steering pressure switch (Figure 2, Item 1).
2. Install primary steering pressure switch (Figure 2, Item 1) on implement pump (Figure 2, Item 5).
3. Install three washers (Figure 2, Item 4) and bolts (Figure 2, Item 3) on implement pump
(Figure 2, Item 5).
4. Connect transmission wiring harness connector (Figure 2, Item 7) on primary steering pressure switch
connector (Figure 2, Item 6).
5. Install two new O-rings (Figure 3, Items 2 and 4), hoses (Figure 3, Items 1 and 6) and tube nuts (Figure 3,
Items 3 and 5) on fitting (Figure 3, Item 7).
Figure 3. Hoses.
0389
END OF TASK