TM 5-3805-255-14
0013
Table 1. Preventive Maintenance Checks and Services (PMCS) for H100C - Continued.
.
LOCATION
ITEM TO
NOT FULLY MISSION
CHECK/
SERVICE
ITEM NO. INTERVAL
CAPABLE IF:
PROCEDURE
Before
Transmission Oil
CAUTION
14
Level
Do not check the transmission oil level or add oil unless the
loader halves are securely locked with the safety bar and pins
provided. Have a second person at the loader controls while
checking the oil.
NOTE
If transmission oil leakage is suspected or if the loader has
been out of operation for a length of time check transmission
oil level gauge with the loader cold and the engine off. Oil
should appear on the gauge during this condition; if not, add oil
before proceeding to the following steps.
a. Work loader until torque converter
a. Loader does not respond
oil temperature gauge registers in
to transmission selection.
RUN (green) area. Make use of all
b. Class III transmission oil
transmission direction gear ranges.
leak.
b. Park loader in a straight position
on level ground.
c. Shift transmission to N (neutral).
Lower bucket to ground and apply
parking brake.
d. Stop engine and install safety bar
e. Start engine and let it run at low
idle (WP 0005).
f. Turn cap of transmission oil level
gauge counterclockwise to loosen it.
g. Remove transmission oil level
gauge and wipe it clean.
h. If transmission oil level is low add
clean oil as necessary. Refer to Table
2, Lubricants, in this work package for
grade and quantity of lubricant
required.
0013-11