TM 5-3805-255-14
0013
Table 1. Preventive Maintenance Checks and Services (PMCS) for H100C - Continued.
.
LOCATION
ITEM TO
NOT FULLY MISSION
CHECK/
SERVICE
ITEM NO. INTERVAL
CAPABLE IF:
PROCEDURE
Before
Primary Air Filter f. Carefully tap side or end of
Filter missing.
11
Element
element against palm of your hand to
(Cont.)
remove loose dust.
WARNING
Particles blown by compressed air are hazardous. DO NOT
exceed 15 psi (103 kPa) nozzle pressure when drying parts
with compressed air. Use a maximum of 30 psi (207 kPa) when
cleaning components. DO NOT direct compressed air against
human skin. Make sure air stream is directed away from user
and other personnel in the area. User must wear protective
goggles or face shield. Failure to follow this warning may result
in injury to personnel.
g. Direct clean, dry compressed air
up and down pleats on clean side
(inside) of element.
h. Inspect filter element for leaks or Filter is clogged or severely
damage by placing a bright light
damaged.
inside element. Inspection of element
on outside will disclose any holes
where concentrated light shines
through. Slightest rupture requires
replacement of filter elements.
i. If faulty or damaged gaskets or
surfaces are noted, correct these
conditions immediately.
j. Inspect element for damage.
k. Inspect contact surfaces of
element and air cleaner body.
l. Install open end of primary
element into air cleaner body over
safety element.
m. Install seal and wing bolt.
n. Install cover. Tighten wing nut.
o. Install clamp (if equipped).
0013-9
