TM 5-3805-255-14
0018
Table 1. Field PMCS for the H100C Loader - (Continued).
LOCATION
ITEM TO
CHECK/
NOT FULLY MISSION
SERVICE
CAPABLE IF:
ITEM NO. INTERVAL
PROCEDURE
Monthly
Engine Oil and
16
WARNING
Filter Change
When servicing this equipment, performing maintenance, or
disposing of materials such as engine/hydraulic oils, coolant,
and fuel, consult your unit/local hazardous waste disposal cen-
ter or safety office for local regulatory guidance.
Engine/hydraulic oils, coolant, and fuel can be very slippery.
Immediately wipe up any spills.
Engine and oil may be hot. Use gloves.
Failure to follow these warnings may result in injury to
personnel.
a. Park loader on level ground and
Class III engine oil leak is evi-
apply parking brake. Run engine until dent.
it reaches normal operating
temperatures, then shut down engine
b. Allow 10 minutes for oil to drain
back into crankcase. Place a container
under crankcase drain plug to catch
oil. Remove crankcase drain plug.
c. After oil has drained completely,
reinstall drain plug.
d. Clean outside of filters to prevent
dirt from entering system while
servicing.
e. Remove spin-on filters by turning
them counterclockwise. Discard filters.
f. Apply a little engine oil to seal of
new filters and thread new filters on by
hand. Turn clockwise until filter seal
contacts header, then turn filter by
hand one full turn more. Do not use
tools to tighten filters.
0018-14