TM 5-3805-255-14
0026
CLEANING AND INSPECTION
00026
1. Clean and inspect all parts IAW General Maintenance Instructions (WP 0019).
2. Inspect intake manifold, exhaust manifold, and flanges for cracks and distortions. Replace if necessary.
CAUTION
When cleaning parts, ensure debris does not enter internal components. Failure to follow
this caution may result in damage to equipment.
3. Clean intake gasket, exhaust manifold gasket, and clean cylinder head gasket surfaces thoroughly.
END OF TASK
INSTALLATION
00026
1. Install three new gaskets (Figure 3, Item 2), intake manifold (Figure 3, Item 1), two washers (Figure 3, Item 4),
nuts (Figure 3, Item 3), washers (Figure 3, Item 11), bolts (Figure 3, Item 10), four washers (Figure 3, Item 6),
and bolts (Figure 3, Item 7) on cylinder head (Figure 3, Item 5).
2. Torque intake manifold bolts (Figure 3, Items 7 and 10) and nuts (Figure 3, Item 3) to 75 lb-ft (102 Nm).
3. Attach upper pick-up tube (Figure 3, Item 8) and lower pick-up tube (Figure 3, Item 9) to intake manifold
(Figure 3, Item 1).
H100C-0870
Figure 3. Intake Manifold.
0026
0026-5