TM 5-3805-255-14
0051
REMOVAL CONTINUED
00051
7. Remove support stands from either end of axle. Lower axle on suitable lifting device until it clears frame.
8. Remove axle from loader.
END OF TASK
CLEANING AND INSPECTION
00051
Clean and inspect axle IAW General Maintenance Instructions (WP 0019).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during the procedure. Ensure that any lifting equipment used is in good
condition and of suitable load capacity. Keep clear of heavy parts supported by lifting
equipment. Failure to follow this warning may result in death or injury to personnel.
END OF TASK
INSTALLATION
00051
1. Use a suitable sling and lifting device to position axle on a support stand placed under differential bowl.
2. With an assistant, move front axle under loader until it is in original mounting position. Support axle with a
suitable support stand placed under each end.
3. Tighten nuts to 3,500 lb-ft (4,745 Nm).
4. Install axle (Figure 1, Item 3), eight bolts (Figure 1, Item 4), nuts (Figure 1, Item 1) and sixteen washers
(Figure 1, Item 2).
5. Install two brake lines on axle assembly (WP 0059).
6. Install propeller shaft on axle (WP 0049).
7. Install two wheel assemblies on axle.
8. Adjust front brakes (WP 0059).
END OF TASK
END OF WORK PACKAGE
0051-3/(4 blank)