TM 5-3805-255-14
0050
ASSEMBLY CONTINUED
11. Position transfer drive assembly, input yoke down, in arbor press. Use a suitable spacer (Figure 15, Item 4)
between yoke retainer and new locknut. Press pressure should be on spacer not yoke ears.
12. Position bearing (Figure 15, Item 3) on shaft (Figure 15, Item 6) and slide output yoke (Figure 15, Item 7) onto
shaft splines. Position a suitable adapter (Figure 15, Item 1) on yoke and carefully, using yoke as a driver,
press bearing cone into cup.
13. Pressure on yoke (Figure 15, Item 7) must be applied slowly and carefully. Rotate housing (Figure 15, Item 5)
while pressing bearing into position. As soon as bearings bind slightly during rotation, stop press pressure.
Figure 15. Bearing Installation.
0050
0050-12