TM 5-3805-255-14
0098
ASSEMBLY CONTINUED
10. Install new gasket (Figure 25, Item 2) and water pump housing (Figure 25, Item 3) on oil pump housing (Figure
25, Item 1).
11. Install 10 bolts (Figure 25, Item 9) and oil pump housing (Figure 25, Item 1) on water pump housing (Figure 25,
Item 3). Tighten bolts to 26 lb-ft (36 Nm).
12. Position flinger (Figure 25, Item 5) on drive shaft (Figure 25, Item 10) so small outside diameter of flinger is
facing out from water pump housing (Figure 25, Item 3). Tap flinger into position on the shaft until a
measurement of 3.557 to 3.567 in. (90.35 to 90.60 mm) is obtained from water pump housing rear face to rear
face of flinger.
13. Install new coolant seal assembly (Figure 25, Item 6) over drive shaft (Figure 25, Item 10).
14. Install new seat (Figure 25, Item 7) into groove of impeller (Figure 25, Item 8).
15. Install new seal (Figure 25, Item 4) on water pump housing (Figure 25, Item 3).
Figure 25. Water Pump Housing Installation.
0098
0098-20
