TM 5-3805-255-14
0102
ASSEMBLY CONTINUED
CAUTION
While lowering converter assembly into housing, check the following:
Stator and ground sleeve hub must spline together.
Accessory drive gear must mesh with accessory driven gears and input pump
driven gear.
Accessory drive gear must also fit over seal ring on ground sleeve hub.
Output shaft must spline into turbine hub.
Failure to follow this caution may cause damage to equipment.
45. Invert converter assembly (Figure 50, Item 2) and, with accessory drive gear (Figure 50, Item 3) facing down,
attach a suitable lifting device to input drive hub (Figure 50, Item 1) mounting holes. Lower converter assembly
into converter housing (Figure 50, Item 4). Remove lifting device.
Figure 50. Converter Assembly Installation.
0102
0102-30