TM 5-3805-255-14
0109
CLEANING AND INSPECTION
000109
1. Clean and inspect all parts IAW General Maintenance Instructions (WP 0019).
2. Replace any damaged or worn parts.
END OF TASK
ASSEMBLY
000109
1. Install valve (Figure 1, Item 11), washer (Figure 1, Item 12), retainer (Figure 1, Item 13), washer (Figure 1, Item
14), bearing (Figure 1, Item 15), washer (Figure 1, Item 21), and new seal (Figure 1, Item 16) on shaft (Figure
1, Item 22).
2. Install spring (Figure 1, Item 10), and check ball (Figure 1, Item 9) on valve (Figure 1, Item 11).
3. Install spring (Figure 1, Item 8), new O-ring (Figure 1, Item 7), and oil inlet valve (Figure 1, Item 6) on shaft
(Figure 1, Item 22). Install pin (Figure 1, Item 5) on shaft (Figure 1, Item 22).
4. Install assembled shaft (Figure 1, Item 22) on range housing (Figure 1, Item 17).
5. Install two pins (Figure 1, Item 3) on plate (Figure 1, Item 6).
6. Install spacer (Figure 1, Item 23), bearing (Figure 1, Item 24), and new seal ring (Figure 1, Item 25) on range
housing (Figure 1, Item 17).
7. Install new gasket (Figure 1, Item 4) and plate (Figure 1, Item 2) on range housing (Figure 1, Item 17).
8. Install eight bolts (Figure 1, Item 1) on range housing (Figure 1, Item 17). Tighten bolts securely.
9. Install new snap ring (Figure 1, Item 20), woodruff key (Figure 1, Item 19), and new snap ring (Figure 1, Item
18) on range housing (Figure 1, Item 17).
10. Install range selector valve on transmission.
11. Install transmission (WP 0048).
END OF TASK
END OF WORK PACKAGE
0109-3/(4 blank)
